Anchor Kit (#165) consists of 4 each:       3" Plastic Anchor       3 1/2" x 1/2" Lag Screw       Metal Washer

Materials Needed for Installation:       Drill with 1/2" bit       Small hammer       5/16" Allen wrench       3/4" socket, 3/4" wrench, or adjustable wrench

1. Place #101 fixed base on surface, align to desired position (direction you want the post/sign to face). Using the base as a template, mark the four (4) holes to establish pattern for drill.

2. Drill four (4) holes 3" deep using a 1/2" bit. Clean holes.

3. Using small hammer, gently tap the anchors into the holes.

4. Place base over the anchors. Put the washer onto the lag screw. Start lag screw through base hole into anchor. Use 3/4" wrench to tighten lag screw snug into base.

5. Place the sign or post into base, check for proper alignment, hand tighten all four socket cap screws. Use 5/16" allen wrench to snug screws.